KOBE Premium Serie Instrucciones De Instalación página 12

Ductwork Installation
7. Use 6" round steel pipe for 30" and 36" models or
8" round steel pipe for 42" and 48" models (follow
building codes in your area) to connect the exhaust
on the hood to the ductwork above. Use duct tape
to make all joints secure and air tight. Refer to
Figure 5.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD
MUST BE PROPERLY GROUNDED. MAKE SURE
THIS IS DONE BY SPECIALIZED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL CODES.
CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
8. Connect the electrical wires.
-
Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color: black to black, white
to white, and green to green as shown on Figure
6.
-
If necessary to hide the electrical wire
connections, push wires back into the wiring box.
Access the wire connections underneath the
hood. To prevent any damage, make sure wires
do not slip between motor or any moving parts.
Install Accessories
9. Attach Oil Tunnel. Refer to Figure 7.
10. Refer to Figure 8.
hood. Push the baffle filter upward.
forward. Pull downward.
11. Repeat until all baffle filters and spacers are resting
against oil tunnel. Refer to page 22.
Final Assembly
12. Turn power ON in control panel. Check all lights and
fan operation.
13. Make sure to leave this manual for the homeowner.
BEFORE
Slide the baffle filter into the
Fit into place.
Figure 5
Figure 6
Figure 7
Figure 8
Slide
10