Eu Declaration Of Conformity; Safety Instructions - IKA MS 3 basic Instrucciones De Manejo

Source language: German
Contents
EU Declaration of conformity
Safety instructions
Unpack
Intended use
Commissioning
Accessories
Maintenance and cleaning
Technical data
Warranty

EU Declaration of conformity

We declare under our sole responsibility that this product corresponds to the
directives 2014/35/EU, 2014/30/EU, 2006/42/EG and 2011/65/EU and conforms
with the standards or normative documents: EN 61010-1, EN 6010-2-051,
EN 61326-1 and EN 60529.
A copy of the complete EU Declaration of Conformity can be requested at
sales@ika.com.

Safety instructions

• Read the operating instructions in full before starting up and follow the
safety instructions.
• Keep the operating instructions in a place where they can be accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and safety and ac-
cident prevention regulations.
• The voltage stated on the nameplate must correspond to the mains voltage.
EN
• The device must only be operated with the original plug-in power supply unit.
• Wear your personal protective equipment in accordance with the hazard cat-
egory of the medium to be processed. There is a risk of:
- splashing liquids
Page
- projectile parts
11
- body parts, hair, clothing and jewellery getting caught.
11
• Set up the appliance in a spacious area on an even, stable, clean, non-slip, dry
12
and fireproof surface.
12
• The feet of the appliance must be clean and undamaged.
13
• Position the knob (C) at the left stop before starting up. Gradually increase the
15
speed. Gradually increase the speed.
16
• Keep hand/arm vibration to a minimum (Directive 2002/44/EC) when operated
17
manually:
17
- Keep the sample container as vertical as possible.
- Only exert the minimum pressure necessary for the mixing process.
- Use attachments for multiple samples when there is a large number of samples.
• If the shaking movement of the appliance increases (resonance), reduce the
speed or pass through the critical phase as quickly as possible.
• Reduce the speed if:
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the appliance begins to move around because of dynamic forces.
• Firmly secure the accessories and vessels in place, otherwise shaking vessels
could be damaged or projected out.
• Check the appliance and accessories beforehand for damage each time you
use them. Do not use damaged components.
• Position one single shaking vessel in the centre and several shaking vessels so
that they are evenly spread out.
• Sharp edged vessels cause wear debris on the attachments.
• Beware of the risk of:
- flammable materials
- glass breakage as a result of mechanical shaking power.
• Only process media that will not react dangerously to the extra energy pro-
duced through processing. This also applies to any extra energy produced in
other ways, e.g. through light irradiation.
11