dirna Bergstrom BYCOOL BLUE LINE SCANIA PGR FLAT Instrucciones De Montaje página 25

FLAT
15
Place console and centre equipment in the most
convenient place of cabin roof. Once centred, re-
move console for later installation.
16
Fasten the fastening supports by tightening the
nut until the outer EPDM seal tightening of the
equipment is between 3 and 6mm.
Important: To avoid possible water leaks into the
inside of the cab the EPDM seal tightening must be
adjusted with the base of the Bycool as indicated
in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
is between 3 and 6 mm.
17 Screw (4) M8 nuts to the support and (4) to the
base of the Bycool.
EPDM seal
10 mm*
(*) (approx. after tightening)
Base
Support
17
25
Check compression
thickness using a
tape measure in the
four corners.
EPDM seal
EN
®
15
16
16