Publicidad
For using spring
pulling button (B). Then, spring must be introduced by hand into the inner space of the machine.
Supports
(C)
are used to regulate the machine height and angle, by adjusting the nuts positions.
1. Insert the wedge shape tool* as it is shown in the picture. A piston will be released, leaving a
gap where the user must fix the needed accesory.
2. For taking out the accesory, the wedge shape tool* must be inserted as explained above. When
the piston is released, the user must pull out the accesory.
3. Proceeding as previously commented, the end of the spring will be freed from the accesory.
1
*Included tool in 2 different sizes.
8
(A)
with any of the accesories shown on page 14, piece must be taken out by
A
INSTRUCTIONS FOR CHANGING THE ACCESORIES
2
C
3
B
Publicidad
