Residual Risks; Important Safety Instructions For All Battery Chargers - DeWalt DCL060 Manual Del Usuario

EN GLI SH
e. To reduce the risk of electrical shock, do not
put worklight in water or other liquid. Do not
place or store worklight where it can fall or
be pulled into a tub or sink.
f. Use only the charger supplied by the
manufacturer.
Safety Rules for Worklights
WARNING: Fire hazard. Do not operate
worklight near flammable liquids or in
gaseous or explosive atmospheres.
Internal sparks may ignite fumes causing
personal injury.
• Vision may be impaired when looking directly
into light.
• Do not expose light to wet or damp areas. Use
only in dry locations. Do not allow any liquid to
get inside worklight. Do not submerge worklight
in any liquid.
• The worklight is intended for household and
commercial use.
• Before using battery, read all instructions and
cautionary markings on battery pack, and
product using battery pack.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
WARNING: Shock hazard. Do not allow
any liquid to get inside worklight. Electric
shock may result.
• Do not expose worklight to rain or snow.
• Use only a proper extension cord that is
necessary to operate the charger. Use of an
improper extension cord could result in risk of
fire, electric shock or electrocution.
• Place the worklight in a position away from any
heat source.
• Do not place any object on top of worklight
or place the worklight on a soft surface that
might block the ventilation slots and result in
excessive internal heat. Place the worklight in
a position away from any heat source.
• Do not operate the worklight if it has received
a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorised
service centre.
20
• Do not disassemble worklight. Take it to an
authorised service centre when service or
repair is required. Incorrect reassembly may
result in a risk of electric shock, electrocution or
fire.
• Remove the battery before attempting to
clean the worklight.
• The DCL060 operates on direct current (DC)
through a fully charged 18V battery pack. Do
not use any other voltage.

Residual Risks

• The following risks are inherent to the use of this
appliance:
– impaired vision when looking directly into light
– burns from touching a hot surface
Labels on Worklight
The following pictograms are shown on the
worklight:
Read instruction manual before use.
Hot surface. Risk of burns. Do not touch.
Do not stare at light source.
Do not use near fire.
DATE CODE POSITION
The Date Code, which also includes the year of
manufacture, is printed into the housing surface.
Example:
2014 XX XX
Year of Manufacture
Important Safety Instructions for All
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual
contains important safety and operating instruc tions
for the DCB105, DCB107 and DCB112 battery
chargers.
• Before using the charger, read all instructions
and cautionary markings on charger, battery
pack and product using the battery pack.
WARNING: Shock hazard. Do not allow
any liquid to get inside charger. Electric
shock may result.