Technical Specifications; Assembly - Yard force YF21-SD-TW Manual Del Operador

TECHNICAL SPECIFICATIONS

Engine type
Engine displacement
Engine speed
Cutting path
Height adjustments
Front/Rear wheel diameter
Ignition
CAUTION! Read complete INSTRUCTION MANUAL before operating this machine.
IMPORTANT! THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory with the exception of those parts left
disassembled for shipping purposes. All parts, such as nuts, washers, bolts, etc., necessary to complete the
assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all
parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure
proper tightness.
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and lower handle and padding holding
control bars to upper handle.
4. Roll lawn mower out of carton and check carton thoroughly for additional loose parts.
ASSEMBLING THE HANDLE
IMPORTANT: Unfold handle carefully to avoid pinching or damaging the control cable.
1. Lift the rear of the deck and place it on a block of wood (not supplied) to secure it.
2. Place the lower handle over the deck and align the holes on the deck with the corresponding holes on
the handle.
3. Secure the lower handle to the deck using the handle knob and bolt (supplied). See Fig. 3.
Hotline: 1-866-902-9690
TECHNICAL SPECIFICATIONS

ASSEMBLY

Fig. 3
handle bracket
knob
Single cylinder 4-stroke
125cc
3100±100 RPM
20"
1.25 " ~ 3.25", 3 positions
7" (178mm)
TCI
bolt
9