Residual Risks; Intended Use; Technical Data - Rebel RB-5002 Manual Del Usuario

• Switch off when transporting the grass trimmer to and from the area to be worked
on.
• Carry the grass trimmer by the handle always with the cutting head stopped.
• Remove the battery before replacing the cutting line. Unintentional starting of the
power tool may pose a risk of serious injury.
• Never fit metal cutting elements. Do not use accessories other than those provided
by the manufacturer.
• The cutting line rotates for a few seconds after switching off the grass trimmer. Wait
until the cutting line stops before placing down the grass trimmer. Rotating cutting
line poses a risk of serious injury.

Residual risks

Even when the power tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the power tool's construction
and design:
• Damage to lungs if a dust mask is not worn.
• Damage to hearing if hearing protection is not worn.
• Health defects resulting from vibration emission if the power tool is being used over
longer period of time or not adequately managed and properly maintained.
• Injuries and damage to property to due to broken accessories that are suddenly dashed.
Warning!
This power tool produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of
serious or fatal injury, we recommend persons with medical implants to consult their physician
and the medical implant manufacturer before operating this power tool.
INFORMATION ABOUT THE POWER TOOL

Intended use

This grass trimmer is intended for trimming grass.
Use the power tool for its intended purpose only. Any other use is deemed to be a case
of misuse. The user/owner of this power tool, not the producer, is responsible for any
damages or injuries caused by improper handling of this power tool.

Technical data

Up to 20 min
Charging time
AC charger (RB-2001-CH)
Input
20 V; 2 Ah, Li-Ion (RB-2001)
1-1,5 h
220 – 240 V; 50/60 Hz
39 EN