Haier HSU-07HC03/R2 Manual De Funcionamiento página 14

Operation
COOL,HEAT and DRY operation
Recommendations:
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
Power indicator on indoor unit lights up.
(2) Select operation mode
Press MODE button. For each press, operation
mode changes as follows:
AUTO COOL
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
Every time the button is pressed, temp. setting decreases 1
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
LO MED HI
Unit runs at the speed displayed on LCD.
In HEAT mode,warm air will blow out after a short period
of time due to cold-draft prevention function.
In DRY mode, when room temp. becomes 2
temp. setting, unit will run intermittently at LO speed
regardless of FAN setting.
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
All manuals and user guides at all-guides.com
Use COOL in summer.
Use DRY in spring, autumn and in damp climate.
DRY HEAT FAN
AUTO
o
C higher than
10
Use HEAT in winter
o
C
o
C
COOL operation starts when room
temp. is higher than temp. setting.
o
Temp. setting+2 C
Temp. setting
On reaching temp. setting, unit
will run in mild DRY mode.
Ultra-low air flow