Campingaz 2 Serie Compact EX Manual De Instrucciones página 16

IFU 4010027880 - 2 Series Compact LX & EX - 20 langues.qxp
Keep away from any parts of the barbecue that get hot.
Check that the flexible hose stretches out normally,
without twisting or pulling.
GB
Check for leaks following the instructions in paragraph g.
Germany, Austria:
Model LX : The unit comes with a flexible hose that is
pre-assembled in the factory.
Model EX : The unit comes with a flexible hose and
regulator that are pre-assembled in the
factory.
The barbecue should be used with flexible tubing that is
suitable for use with butane and propane gas. Hose length
should not exceed 1.50 metre. It should be replaced if it is
damaged or cracked, when required by national
regulations or at the end of the part lifecycle. Do not pull
or pierce the tubing. Keep away from any parts of the
barbecue that get hot. Check that the flexible hose
stretches out normally, without twisting or pulling.
Flexible tubing connection: to connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
provided:
- no. 14 wrench to tighten the connector
- no. 17 wrench to tighten the nut on the tubing
Check for leaks following the instructions in paragraph g.
f) LID
Handle the lid carefully, especially during operation. Do
not lean over the base.
g) CHECKING FOR GAS LEAKS
1) Work outside, away from all sources of ignition. Do not
smoke.
2) Make sure the control knobs are in the "off" (O)
position.
3) Connect the flexible tubing to the connector and
barbecue as described in part e).
4) Fit the regulator onto the gas cylinder in accordance
with its instructions.
5) Use a gas leak solution to test for leaks. Important:
never use a naked flame to check for gas leaks.
6) Apply the solution to the connections cylinder/
regulator/ hose/ apparatus (the control knobs should
remain closed: "off" position (O). Open the gas cylinder
valve.
7) Bubbles in the gas leak solution indicate that there are
gas leaks.
03/09/2013
8) The leak can be stopped by tightening any hose
connection or replacing any faulty component. The
barbecue must not be used until the leak is stopped.
9) Close the valve on the gas cylinder.
Important:
Check for leaks at least once per year and each time the
gas cylinder is replaced.
h) PRIOR TO USE
Never use the barbecue until the instructions have been
read carefully and understood. Also, make certain that:
- there are no leaks
- the venturi tubes are not blocked (example: spider
webs)
- the hose does not touch
any components which
may get hot.
i) LIGHTING THE GRILL BURNERS
Read steps 1 to 5 before beginning with step 1.
1) Never light the barbecue with the lid closed, only
with the lid open.
2) Make sure the control knobs are in the "off" (O)
position.
3) Open the gas cylinder valve.
4) Model 2 Compact LX Series
Press one of the 2 control knobs and turn it to the full
flow ( ) position, then immediately press the igniter
button ( ) until you hear the click. Repeat 3 or 4 times
if necessary until the burner is lit. If the burner fails to
light, turn the control knob to the "off" position (O). Wait
5 minutes before repeating the operation.
Model 2 Compact EX Series
Push an adjustment button down and turn it anti-
clockwise until it is in the full flow position (
immediately press the ignition button down ( ) until the
burner lights.
If the burner does not ignite after 10 secondes, turn the
control knob to the "off" position (O). Wait 5 minutes
before repeating the operation.
5) As soon as the burner is lit, the other burner
automatically lights when the second control knob is
placed in the full flame (
the automatic igniter button again.
16
09:20 Page 3
), then
) position without pushing