Koala Kare KB310-SSWM Instrucciones De Instalación Y Funcionamiento página 6

KB310-SSWM
Installation Instructions
1/4"
(6mm)
Fig. 4
Fig. 5
Fig. 6
Fig. 7
6 6
Step 4:
• Take the flange and position it inside the skirt. Make
sure the mounting holes are towards the floor.
Flange should be centered inside the skirt.
• Use the mounting holes to mark and predrill for
the mounting screws. Screw in the top two screws,
make sure you leave ~1/4" (6mm) of thread exposed
for hanging the main unit. Fig. 4
Step 5:
• Open the main unit by pulling up on the frame and
remove the plastic liner dispenser. Set it to one side.
Fig. 5
• Lift the unit into the flange locating the key holed
mounting holes over the mounting screws. Fig. 6
This may be easier with the assistance of a second
person.
Step 6:
• Secure the unit through the remaining mounting
holes with the provided mounting screws. Fig. 7
• Tighten the upper mounting screws.
*Diagrams are not to scale.