i.safe MOBILE IS530.M1 MINING +GD Manual De Inicio Rápido página 7

Operate approved accessories in explosion hazardous areas only on the ISM interface of the
device. Wired connections via the USB interface are prohibited.
Connect the plug of the accessory securely to the ISM interface of the device and check that
the plug is seated correctly and securely before entering explosion hazardous areas.
Close the ISM interface with the cover provided when you are not using accessories.
Only use USB interface outside of explosion hazardous areas.
Under no circumstances should you open the cover of the USB interface in explosion hazar-
dous areas.
Approved accessories can be connected to any ISM interface and to the USB interface.
Loosen the screw on the ISM interface cover using the Screwdriver provided and remove the
cover as shown. The Screwdriver is included in the accessory package.
Connect the plug of the approved accessory to the ISM interface as shown.
Hand-tighten the screws using the Screwdriver provided.
Check that the plug is seated correctly and securely.
The USB interface is used for charging and data transfer.
Connect approved accessories or other devices to the USB interface only by using the
i.safe PROTECTOR 2.0 Type C USB Cable.
MAINTENANCE/REPAIR
Contact the i.safe MOBILE repair service at www.isafe-mobile.com/en/support/service if
the device is not working normally, if the device needs to be repaired or if a replacement part
is required.
RETURN SHIPMENT
Contact the i.safe MOBILE repair service at www.isafe-mobile.com/en/support/service.
CLEANING
Turn off the device before cleaning.
Do not charge the device while cleaning.
Do not use chemical agents for cleaning.
Clean the device and the Power Adapter with a soft, moistened antistatic cloth.
Clean the display screen regularly with a soft, antistatic cloth.
EN 7