sunjoe 24V-SB10-LTE Manual Del Usuario página 9

Fig. 1
Push lock
button (on
both sides)
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 1 hr 20 min to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery.
Secrets to a Long Lasting
SharperBlade
CONGRATULATIONS! You are about to experience a faster,
easier way of grooming your lawn's edge and managing
weeds.
First, you will notice that there are obvious differences between
your SharperBlade
shape. These differences require you to operate your trimmer +
edger slightly different:
1. Use MINIMAL pressure when edging against concrete,
brick, or stone. Since the SharperBlade
string, you may feel the need to put pressure on the blade
while edging. The more pressure you apply, the FASTER
the blade will wear. In contrast, the less pressure you
apply against hard surfaces, the LONGER the blade will
last! The SECRET is to keep the blade just off the
hard surface.
2. NEVER FORCE your SharperBlade
with an impact against any hard surface, may cause
the blade to buckle near the center hub, and tear. The
SECRET is to allow the SharperBlade
without extra effort.
Pressure =
Battery
indicators
Assembly
Before using the cordless grass trimmer + edger, follow these
instructions to assemble.
m
WARNING!
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
Fitting the Auxiliary Handle
1. Remove the handle knob and bolt that that come
pre-assembled on the auxiliary handle (Fig. 3).
Fig. 3
9
™
and string line, among which are size and
™
is more rigid than
™
. High speed, along
™
to do ALL the work
™
LONG
LASTING
Do not insert the battery until assembly is
Handle knob
Auxiliary handle
Bolt