sunjoe 24V-GT10-CT Manual Del Operador página 9

When to Charge the 24V iON+ Lithium-
Ion Battery
NOTE: The 24V iON+ lithium-ion battery packs do not develop
a "memory" when charged after only a partial discharge.
Therefore, it is not necessary to run down the battery pack
before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your 24V iON+ lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Charging the Battery
1. Press the push lock buttons on the battery to pull the
battery pack out of the equipment (Fig. 1).
Fig. 1
Push lock button
(on both sides)
2. Depending on your Snow Joe
model, how to recharge your lithium-ion batteries will
vary. You may either insert your 24-volt batteries into the
24VCHRG-QC Quick Charger (sold separately) or the
24VCHRG-DPC Dual Port Charger (sold separately)
(Figs. 2 – 3).
Fig. 2
Charging
red
24VCHRG-QC
quick charger
(Sold separately)
Fully
Charged
green
+ Sun Joe charger
® ®
Battery pack
Fig. 3
Charging
red
Fully
Charged
green
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating
lights which will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
The chargers do not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
Before using the cordless grass trimmer, follow these
instructions to assemble.
m
WARNING!
Do not insert the battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
Connect the Poles
1. Connect the poles by inserting the upper pole assembly
into the lower pole assembly (Fig. 4).
9
Battery pack
24VCHRG-DPC
dual port charger
(Sold separately)