Team International TEAM MC 3 Manual De Instrucciones página 8

Fax +32 2 359 95 50
We recommend that when using your product you operate the motor unit in short on/off
pulses. This will give better chopping, mixing, etc. It will also protect the motor against a
too long use.
The chopper is designed to be used exclusively in its delivery state (bowl, lid and blades in
good state) because it gives all the needed securities. Do not try to substitute one of those
pieces by another one and if you have to replace one, contact your after-sales service.
Caution: your appliance has a security device that avoids excessive starting. Do not try to
overrule this device, as it could be very dangerous for you.
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not designed for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor. Please refer to the
rating label for the maximum continuous usage time (KB xx min where xx is the allowed
maximum usage time). The breaks should last at least 10 minutes.
MOUNTING AND USE OF THE MINI-CHOPPER (see page 3)
Caution: for your own safety and a good functioning it is absolutely necessary to respect the
mounting described hereunder.
• Place the blade of the mixer fitting in the jug (1).
• Put the ingredients in the jug.
• Place the lid on the jug respecting the positioning of its openings-out (2). If necessary, turn
the lid until it is correctly placed on the jug.
• Place the unplugged motor block on the jug (3) respecting the positioning of the
openings-out. If the motor block is not mounted correctly, it will be impossible to start the
appliance.
• Plug in the appliance.
• To start, press the motor block with your hand holding the jug with the other hand.
• To remove food, unplug and proceed the other way round, but pay attention not to get
injured, as the blade is very sharp.
TIPS FOR USE
• Your appliance is not intended to work for long periods. So if your preparation requires
more than 1 minute of continuous use, it is absolutely necessary to follow breaks. The
breaks should last at least 2 minutes to allow the motor to cool down.
• We advise you to chop the food by fits and starts and if necessary to mix them with a
spatula between two chopping processes following the safety instructions.
• If you chop pieces of meat or cheese, we advise you to cut them into small pieces of 1 to
1.5 cm beforehand in order to obtain a homogeneous and fine chopping. Otherwise you
could obtain lumps in your preparation.
CLEANING
• Unplug from outlet before cleaning.
• You can wipe the motor block with a lightly damp cloth. Never immerse it in water or any
other liquid. If this happens, do not plug it in, let it dry for at least 24 hours before using it
again. If this is not enough, bring your appliance back to a competent qualified
electrician.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/36
TEAM MC 3 - 091208