Cleaning And Maintenance - Beurer MP 64 Instrucciones De Uso

When filing, always move from the outside of the nail towards the tip!
Check the results regularly during the treatment. Stop treatment as soon as
it becomes unpleasant.

7. Cleaning and maintenance

Always unplug the mains part from the socket before cleaning the device.
– Clean the device with a slightly damp cloth. If it is very dirty, you can also
moisten the cloth with a mild soapy solution.
– For hygiene reasons, you may use alcohol and a cloth or brush to clean
the attachments if required. Please dry carefully afterwards.
– Do not drop the device.
– Please make sure that no water enters the device. If this should happen,
only reuse the device once it has fully dried out.
8 – Flame-shape cutter
Removes ingrown nails. For this purpose, please
carefully position the flame-shape cutter on the
area to be treated and remove the necessary nail
parts.
9 – Nail cutter
The nail cutter is a precision tool. Please
exercise care when using this attachment, as
careless use can quickly result in injury. This at-
tachment can be used to expose ingrown nails
and cut dead nail parts. Operate the nail cutter
at a low speed.
10 – Sapphire cutter, round
This accessory attachment is for carefully remov-
ing corns. If you are using this attachment, please
keep in mind that you may soon penetrate deeper
into the skin when removing the skin layers of the
corn, therefore damaging the periosteum
11 – Protective cap for nail dust
This attachment ensures nail dust and skin cells
are collected.
26