DeLOCK 87666 Manual Del Usuario página 3

English
Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
Installation
1.
Ensure your computer system and monitors are powered off.
2.
Connect the DisplayPort splitter to your video source.
3.
Connect the outputs of the splitter to the monitors with optional HDMI cables.
4. Power on your monitors followed by your computer system.
Note
• The splitter is a Multi-Stream Transport (MST) hub and supports extended
desktop configuration. MST mode is only available on DisplayPort 1.2 graphics
cards. The splitter will show the same image (mirror) on both outputs if a
graphics card with DisplayPort 1.1 is used.
• A single DisplayPort 1.2 connection has a limit amount of bandwidth. This limits
the number of displays that can be connected through an MST hub depending
on the displays resolution, timing and refresh rate. Please see below for
bandwidth usage of different resolutions:
1920 x 1080 @ 60 Hz uses 22 %, 1920 x 1200 @ 60 Hz uses 30 % bandwidth
2560 x 1440 @ 60 Hz uses 35 %, 2560 x 1600 @ 60 Hz uses 38 % bandwidth
3840 x 2160 @ 30 Hz uses 43 %, 3840 x 2160 @ 60 Hz uses 95 % bandwidth
• Please use short length and high-quality cables, especially for higher
resolutions.
-3-