Craftsman 900.11647 Guia De Inicio Rapido página 5

479218-00 01 11647 Searsnewone
Carton Contents:
• 4 - Sanding Sheets (1) each 80 and 120
Grits and (2) 240 Grit
• 3 - Pads (1) each Abrasive, Steel Wool
and Foam Polishing
• 8 – Patented Reversible Tips (2) each
80 and 120 Grits and (1) 240 Grit
• 6 – Pad Tips, (2) each Abrasive, Steel
Wool and Foam Polishing
• 3 – Finger Detail Sanding Tips 240 Grit
• 1 - Finger Detail Attachment
• Storage Bag
SWITCH
To turn the tool ON, hold it as shown in
Figure1 and push the portion of the switch
marked "I". To turn the tool OFF, push the
portion of the switch marked "O".
On Off Switch
1
SANDING
Grasp product as shown in Figure 1 and
turn it on. Move it in long sweeping strokes
across the surface, letting it do the work.
Light pressure is all that is required for
sanding, polishing or scrubbing.
Excessive pressure will slow the tool and
produce inferior results. Check your work
often, product is capable of removing
material rapidly.
DETAIL SANDING
Your tool is equipped with a Hook and
Loop teardrop base which allows you to
use it on both large flat surfaces and in
tight spots or corners.
WARNING: Always unplug product from
power supply before any of the following
operations.
All manuals and user guides at all-guides.com
4/12/07 8:15 AM Page 5
FITTING SANDING SHEETS OR PADS
( FIG. 2)
• Detach and save the two diamond-
shaped tips from the sanding sheet or
pad.
• Hold the tool with the sanding base
facing upwards.
• Place the sanding sheet or pad onto
the sanding base.
• The diamond-shaped tip can be
reversed or replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip is worn, remove it
from the sanding base and fit a new tip.
2
TIP OF THE SANDING BASE (FIG. 3)
When the tip of the teardrop sanding
base becomes worn, it can be reversed
or replaced.
• Remove the base tip.
• Reverse or replace the base tip.
3
Base Tip
Sandpaper
5
Extra Tips
Rotate 180° Base