ZAZZERI 100 3600 1401 A00 Installacion Y Mantenimiento página 6

Temperature range
Water supply pressure
difference of hot/cold pressure max 1.5 bar recommended minimum possible
In the event of pressure over 5 bar, install a centralised pressure reducer.
Installation advice
Before fitting a tap, it is essential to bleed the pipes, especially in case of new installations.
Given the generally poor quality of drinking water, the use of a central filter at source or
of filter cocks below the basin is recommended.
The installation of filters is essential when fitting traditional taps with a ceramic disc
movement and single-lever mixer taps.
Fitting the cartridge
The socket for the tap structure must be clean and free of any frazes, shavings and
impurities, especially on the washer surfaces; avoid the use of grease, oil, paint or thinners.
Lubricate the diametric O-Ring with silicone-based neutral grease. The tightening of the
ring nut should be free but without any play; the ring nut should fully cover the cartridge
plate.
Tighten with 10 ÷ 12 Nm torque. Avoid unnatural overloading of the lever both during use
and during packing, transportation and installation.
Cleaning
A soft cloth is ideal for cleaning the taps. Under no circumstances should abrasive,
caustic or aggressive substances be used.
Chrome - Chrome-plated surfaces should be cleaned with a delicate detergent, or with
soap and water. To eliminate limescale, detergents containing mineral acids (for example
hydrochloric acid) should not be used and aggressive organic acids (for example acetic
acid) only if diluted.
We recommend the use of products with a base of citric acid.
After cleaning, the tap should be thoroughly rinsed and dried carefully.
6
ZAZZERI TAP FITTINGS
max 80°C recommended 60 ± 5°C
min 0.5 bar max 3 continual bar - 5 occasional bar