Safety Information - Style selections RBETB6026-91 Manual De Instrucciones

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble or install the product.
WARNING
• Always wear safety glasses or eye protection when using power tools. Use a dust mask
or respirator for applications that generate dust.
• DO NOT proceed if any doubt arises about the correct or safe method of performing anything found
in this manual. The installation of this product can require the use of power tools. Do not use power
tools without adequate training. If necessary, hire or consult a trained professional for expert assis-
tance before continuing.
CAUTION
Use care when opening the box so that you do not damage the panels.
Store panels in a flat area to avoid warpage until the time of installation. Do not store the panels
outside of the original packaging in a vertical position.
Make sure the walls are the correct size and are in good condition. Installation of damaged product
will void the warranty.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 120 minutes
Tools Required for Assembly (not included): Level, Tape Measure, Pencil, Compass Scribe, Circular
Saw, Sanding Block, Shims, Drill and 3/8 in. Drill Bit, 1/2 in. Hole Saw, Caulk Gun, Safety Glasses,
Dust Mask, Saber Saw, Denatured Alcohol, Clean Shop Towels, Masking Tape
Helpful Tools (not included): 2 in. x 4 in. Wood Bracing
Prepare the area with moisture-resistant drywall, marine-grade plywood or tile backer board. Never
install directly on any wall construction that is or may become damp. When installing over ceramic
tile, check for loose tiles. If you find any, correct the problem. Make sure the area to be covered is
uniform in support. If not, build up the areas without tile. Remove the bottom row of tile and cut a
ventilation gap in the substrate. On every installation, make sure there is a 1/2 in. clearance between
the top of the tub deck and the bottom of the substrate. This will allow for ventilation and keep water
leaks from wicking up the substrate.
3
Lowes.com