General Cleaning - NORSE PROFESSIONAL SK125 Manual De Operación

SK125

General cleaning

Distance from Cleaning Surface
Another factor that determines the impact force of the water is the distance from the variable nozzle to
the cleaning surface
Angle to the Cleaning Surface
When spraying water against a surface, maximum impact is generated when the water strikes the
surface head on. However, this type of impact tends to cause dirt particles to embed in the surface,
thereby preventing the desired cleaning action. The optimum angle for spraying water against a surface
is 45 degrees.
Avoid Damaging Surfaces
Damage to surfaces occurs because the impact force of the water exceeds the durability of the surface.
Never use a narrow high impact stream or a turbo / rotary nozzle on a surface that is susceptible to
damage.
The surest way to avoid damaging surfaces:
1. Adjust the nozzle to a wide spray pattern.
2. Place the variable nozzle approximately 4-5 feet from and 45 degrees to the cleaning surface.
3. Vary the spray pattern, spray angle and the distance to the cleaning surface until optimum
cleaning efficiency is achieved without damaging the surface.
A cleaning tool is supplied to remove any debris from the nozzle before and after use.
Looking After your Product
1. This pressure washer is not meant to pump hot water. Never connect to a hot water supply.
2. Never operate the unit for more than one minute without spraying water. This will cause a heat
build-up that can damage the pump.
3. Only use the nozzles supplied with the machine.
English
© NØRSE 7