Drawing From A Barrel - NORSE PROFESSIONAL SK125 Manual De Operación

SK125
1. Unscrew the top of detergent tank and fill with detergent.
2. Put the top of detergent applicator back on.
3. Set variable nozzle to detergent feature.
4. Apply the detergent so it thoroughly covers the cleaning surface. Apply from bottom to top to
prevent the detergent from sliding down and streaking.
5. Allow the detergent to remain on the surface for a few minutes. This is a good time to use a
brush to lightly scrub heavily soiled areas. Never allow detergent to dry on the cleaning surface.
6. Rotate the variable nozzle from the detergent setting to the wide angle fan spray.
7. Rinse detergent from surface.
8. Rinse the detergent tank with clean water following each use.
9. Final rinse. Make sure you thoroughly rinse the surface and that all detergent has been removed.
Shut down
1. Make sure all detergent is flushed from the system.
2. Turn off the motor.
3. Turn off the water supply.
4. Trigger the spray gun to de-pressurise the system.
5. After each use, wipe all surfaces of the pressure washer with a clean, damp cloth.

Drawing from a barrel

First ensure the machine is switched off before connecting / disconnecting any hoses or attachments.
Instead of attaching the hose from pump to tap, use the supplied hose and filter set placing the filter end
in the water supply.
It is advised that the water supply is on the same level as the washer. If you struggle to get initial suction,
remove the outlet hose from the pump and try drawing again - this reduces the pressure on the pump
making it easier to draw. Once flowing, turn engine off and reconnect outlet hose before re-starting.
Ø13
© NØRSE
English
9