Garden Treasures MZ12646CA Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Turn the bowl and pump assembly (H) upside down on a soft
surface, such as carpeting. Attach center post (I) to bowl and
pump assembly (H) using stainless steel washers (DD) and
screws (EE).
Hardware Used
DD
Ø8 Stainless Steel Washer
EE
M8 x 20mm Screw
2. Route power cord out of the bottom of fountain through the
center of the base (J). Then, attach base (J) to center post (I)
with stainless steel washers (DD) and screws (EE).
Hardware Used
DD
Ø8 Stainless Steel Washer
EE M8 x 20mm Screw
3. Turn assembly upright. Make sure the preassembled pump is
set to the maximum water flow position (indicated by a plus sign
(+)).Then, screw pipe (G) into mounting bracket on pump. Place
bottom spacer (F) over the mounting bracket, then place center
bowl (E) over bottom spacer (F). Secure with rubber gasket
(CC), plastic washer (BB) and nut (AA).
Hardware Used
AA
M16 Nut
BB
Ø16 Plastic Washer
CC
Ø16 Rubber Gasket
x 3
x 3
x 3
x 3
x 1
x 1
x 1
4
1
I
H
2
J
I
3
AA
BB
CC
EE
DD
EE
DD
E
F
G
H