Gardena EasyCut Li-18/23 Instrucciones De Empleo página 10

Releasing a cutting filament
that has gone into the
cassette or which has fused:
Y
z 37
Problem
The trimmer no longer cuts
The filament cannot be
extended
The trimmer does not start
The filament consumes
quickly
The trimmer stops.
Error-LED flashes
ß
W
Charging indicator lamp
the charger does not light up
Charging control lamp
on the charger flashes rapidly
(twice per second)
All manuals and user guides at all-guides.com
If the cutting filament has disappeared into the filament cassette
or if the automatic filament extension still doesn't work after
pulling the cutting filament
filament cassette
1. Remove the battery.
2. Remove the filament cassette
7. Maintenance "Replacing the filament cassette".
3. Unwind the cutting filament
and the cutting filament
the cassette
X
4. Clean the automatic mechanism lever
The automatic lever must move freely.
5. Insert the filament cassette again as described under
7. Maintenance "Replacing the filament cassette".
U
Possible Cause
Filament cassette empty.
Cutting filament too short or the
automatic filament extension
does not work.
Cutting filament inside the
cassette or fused.
The filament became too dry and
brittle (e. g. over the winter).
Battery is flat.
Battery not pushed onto the
handle properly.
Motor blockage.
Frequent contact between the
filament and hard objects.
Battery overload.
High temperature. The allowed
operation temperature was
exceded.
on Battery charger or charging
9
cable not plugged in properly.
Charging error.
9
it may be fused together in the
U
.
Y
as described in
Y
, clean the filament cassette
U
and wind the cutting filament
U
once more.
Y
Remedy
v R eplace the filament cas sette
(see 7. Maintenance
"Replac ing the filament
cassette" ).
v P ull the filament out of the
cassette manually.
v R elease filament that has
disappeared into the cassette
or fused together.
v P lace the filament cassette in
lukewarm water for approx.
10 hours.
v Charge battery
(see 4. Initial Operation).
v Push battery onto the handle
and make sure that the locking
buttons snaps in correctly.
v Unblock and restart the
device.
v Avoid contact between the
filament and hard objects.
v Wait for 10 sec. Press button
on the battery and restart.
v Leave battery to cool for
approx. 15 min. Press button
on the battery and restart.
v Plug in battery charger and
charging cable properly.
v Unplug charger and plug
in again.
Y
onto
U
.
ß
37
ß
B
ß
B
21