Safety Notes; Installation Instructions; Symbol Description; En Instructions For Use / Assembly Instructions - Hansgrohe 32122000 Instrucciones De Montaje

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Do not allow the streams of the shower touch sensi-
tive body parts (such as your eyes). An adequate
distance must be kept between the shower and you.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The mesh washer must be insert to protect the over-
head shower against incoming dirt by pipework. In-
coming dirt leads to defects or/and can damage parts
of the shower; such caused faults voids all liability and
guarantee claims.
• During installation of the product by qualified trained
personnel, make sure that the entire fastening surface
is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply the
product and has no weak points.
• To avoid cross flow, connect the shower only to check
valves, to the sanitary fittings specifically provided for
this purpose, or to fittings with integrated backflow
preventers in the water connections.
• Hansgrohe mixers can be used together with hydrauli-
cally and thermically controlled continuous flow heat-
ers if the flow pressure is at least 0,15 MPa.
4
English
Operation
If the shower is connected to a shut-off valve, this must be
closed after every use of the shower.
Technical Data
Rate of flow by 0,3 MPa:
Operating pressure:
Recommended operating pressure
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 31)
Spare parts (see page 32)
Special accessories (order as an
extra)
service tool #95158000
(see page 32)
Cleaning (see page 32) and en-
closed brochure
6 l/min
max. 0,6 MPa
0,1 - 0,4 MPa
max. 60°C
max. 70°C / 4 min