Berner BCLLD Instrucciones De Manejo página 15

Important Safety Instructions
for Batteries
WARNING: Batteries can explode, or
leak, and can cause injury or fire. To
reduce this risk:
• Carefully follow all instructions
and warnings on the battery label
and package.
• Always insert batteries correctly
with regard to polarity (+ and
–), marked on the battery and
the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries.
Replace all of them at the same
time with new batteries of the same
brand and type.
• Remove dead batteries immediately
and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach
of children.
• Remove batteries if the device will
not be used for several months.
Package Contents
The package contains:
1 Digital laser detector
1 Clamp
1 Battery 9V
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 2)
WARNING: Never modify this
attachment or any part of it. Damage
or personal injury could result.
a. LCD display window
b. Speaker
c. Battery compartment cover
d. Marking notches
e. Power button
f. Volume button
g. Accuracy button
h. Magnets
i. Sensor window
j. Clamp latch
k. Tracks
l. Rail
m. Latch
n. Latch hole
o. Clamp knob
The detector gives both visual signals through the
LCD display window (a) and audio signals through
the speaker (b) to indicate the location of the
laser beam.
The Berner Digital Laser Detector can be used
with or without the detector clamp. When used with
the clamp, the detector can be positioned on a
grade rod, leveling pole, stud or post.
INTENDED USE
The Berner Digital Laser Detector (BCLLD/
BCLLD-G) helps in locating a laser beam emitted
by the laser in bright light conditions or over long
distances. The detector can be used in both indoor
and outdoor situations where it is difficult to see the
laser beam.
BCLLD is designed exclusively for use with the
BCLL BASIC and BCLL TOP line lasers and other
compatible B rner Red line lasers. It is not for use
e
with rotating lasers.
BCLLD-G is designed exclusively for use with the
BCLL-G BASIC and BCLL-G TOP line lasers and
rner Green line lasers. It is not
other compatible B
e
for use with rotating lasers.
DO NOT use under wet conditions or in presence
of flammable liquids or gases.
The digital laser detector is a professional
laser accessory.
DO NOT let children come into contact with the
attachment and laser. Supervision is required when
inexperienced operators use this laser.
ASSEMBLY AND ADJUSTMENTS
WARNING: Refer to the manual of the
tool to be used with this attachment.
Batteries (fig. 1)
The digital laser detector is powered by a 9-volt
battery. To install the battery provided, lift up on
the battery compartment cover (c). Place the 9-volt
battery in the compartment, aligning the battery as
shown on the embossed icon.
ENGLISH
13