Step 9: Placing And Leveling The Range - Thermador PROFESSIONAL PRO HARMONY PRG304H Manual De Instalación

4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly below the hinge receiver with a
T-20 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted
(Figure 22).
Figure 22: Hinge Receiver Adjustment Screw
Data Rating Label and Wiring Diagram
Locations
Data rating labels contain the model and serial numbers.
They can be found under the front edge of the rangetop,
with oven door open or removed.
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.
Data labels visible Data labels visible Data labels visible
after the door after the door after the door
is open. is open. is open.
Data labels & wiring Data labels & wiring Data labels & wiring
diagrams placed diagrams placed diagrams placed
behind toe behind toe behind toe
kick panel. kick panel. kick panel.
Figure 23: Data Rating Label Location
English 22
All manuals and user guides at all-guides.com
Step 9: Placing and Leveling
the Range
Leveling Leg Adjustment
For proper performance, the range must be level. This is
especially important for all products that have the griddle
feature. Priority should be placed on ensuring that the oven
cavities are also level for optimum cooking performance.
1. Measure the countertop heights first with a tape
2. Rotate the legs using a 12" (305 mm) adjustable
3. Progression of the height adjustments should be
4. Final height adjustments of the two rear legs take place
5. As the range is moved into its final, installed position,
CAUTION!
The top edges of the range's side panels must be on the
same or higher level as the adjacent countertop. If the
range is operated while at a lower height relative to the
adjacent cabinet, the cabinet could be exposed to
excessive temperatures, causing damage to the cabinet
and countertop (see Figure 25 on page 23).
measure and add an additional 1/16" - 1/8" (2-3 mm).
Adjust the legs accordingly prior to pushing the range
back to its final location.
wrench on the flat sides of each foot.
alternated proportionally between the four corner legs,
until the top edges of the range's side panels are close
to matching the counter top height.
before moving the range into its installed position in the
cabinet.
verify that the Anti-Tip Bracket is in a position to
engage the leg (see "Step 4: Installing the Anti-Tip
Device" on page 11). This can be verified by viewing
through the opening near the floor.
Figure 24: Leveling Legs