Leakage Tests; Distance From Surfaces - Jocel JAT007391 Manual De Instrucciones

LEAKAGE TESTS

Your Outdoor Patio Heater has been checked for leaks at all the factory-made
connections. To check the connection of the gas hose/regulator/LPG cylinder.
1. Make leak test solution by mixing 1 part washing up liquid and 3 parts waters.
2. Spoon several drops (or use squirt bottle) of the solution onto the gas hose/regulator
and regulator/LPG cylinder connection.
3. Inspect the connections and look for bubbles.
4. If no bubbles appear, the connection is safe.
5. If bubbles appear, there is leak, loosen and re-tighten this connection. Repeat the test.
If bubbles form again, stop trying; contact your local dealer for assistance
6. Leak test annually, and whenever the gas cylinder is removed or replaced.
NOTE: In the event of gas leakage, the appliance must not be used or if already alight,
the gas supply must be shut off and the appliance investigated and rectified before it is
used again.

DISTANCE FROM SURFACES

This heater is primarily used for the heating of outdoor
patios (decks, spas, pools and open working areas).
Combustible materials are considered to be wood,
compressed agglomerates, plant fibers, plastic or other
materials that are capable of being ignited and burned.
Always make sure that adequate fresh air ventilation is
provided. Follow the spacing tolerances shown in the
following figure right at all times.
This heater must be placed on level, firm ground.
Never operate in an explosive atmosphere. Keep away
from areas where gasoline or other flammable liquids or
vapors are stored or used.
43