Intex Krystal Clear 638R Manual Del Propietário página 6

SETUP INSTRUCTIONS (continued)
Position this product away from the pool, so as to prevent children from
climbing on it and accessing the pool.
It is essential to change any damaged element or set of elements as soon as possible. Use
only parts approved by the manufacturer.
To inspect and change the filter cartridge, disconnect line cord, unscrew the pool inlet nozzle (10)
and strainer grid (11) from the strainer connectors and insert the hat-like plugs into the strainer
connectors before servicing the filter. After service, open the air release valve, remove the plugs,
allow any air to escape through the valve before tightening the valve again and replace the pool
inlet nozzle (10) and strainer grid (11). The pump is now primed with water again and may be
turned on.
FILTER HOUSING
COVER
THREADED FILTER
HOUSING COLLAR
FILTER
CARTRIDGE
INSIDE
UPPER PUMP
CONNECTION
LOWER PUMP
CONNECTION
The power cord plug to the 220-240 volt electrical power source of the filter pump must be
positioned more than 3.5 m away from the pool walls. Check your local authorities to determine
the appropriate standard and requirements for "electrical installation of swimming pools and basins
equipment". The following table is for reference only:
Country/Region
International
France
Germany
The Netherlands
SAVE THESE INSTRUCTIONS
(106) MODEL 638R FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/11/2018
WARNING
POOL INLET
AIR RELEASE
AIR ADAPTOR
VALVE
HOSE
HOSE CLAMP
WATER LEVEL
AIR JET
VALVE
STRAINER GRID
(REMOVE)
INSIDE OF POOL
Standard Number
IEC 60364-7-702
NF C 15-100-7-702
DIN VDE 0100-702
NEN 1010-702
English
106A
POOL INLET
JET NOZZLE
(REMOVE)
PLUG
Page 6