Initial Configuration; Airzone Blueface And Think Thermostats - Airzone RADIANT365 Guía De Instalación Rápida

ES
EN
FR
IT
PT
DE

INITIAL CONFIGURATION

AIRZONE BLUEFACE AND THINK THERMOSTATS

Start the configuration using the Blueface master thermostat.
Important: Once you start the process, it cannot be interrupted. You will be able to modify the desired parameters later.
Language/Country
Select your language and country. These are the available languages: Spanish, English, French, Italian, Portuguese and German.
To associate a wireless Think thermostat, start the radio channel search:
Setting wireless device
- Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
open, you have 15 minutes to make the association. If that period of time expires, start
the process over again. Remember not to open more than one module at the same time,
it may alter the process. You can also open the channel association radio through the
Blueface and Think (see section System parameters).
IMPORTANT: not to open more than one radio channel at the same time, it may alter the process.
- Start the radio channel search, to do so, press Airzone to start the search.
- The controller will display the different wireless zone modules found, with the signal level of each one of them. Select
the wanted module and press "Check", the selected module will begin to "beep" to be identified. Verify the range is
correct (30% minimum) and confirm.
Zone address
Select the zone associated to the thermostat.
Important: The system can control up to a maximum of 10 valves, distributed over a maximum of 8 zones.
In zones without an associated thermostat, the room temperature will be read by the thermostatic head with the lowest association
number for that zone.
24
Main control board activity
D3
Main control board power
D11
D19 Association channel: active
Meaning
Blinking
Solid
Solid
Green
Red
Red