Kärcher IVC 60/24-2 Tact 2 Manual De Instrucciones página 9

Dry vacuum cleaning
CAUTION
Please note the following when switching from wet
to dry vacuum cleaning:
If you vacuum dry dust while the filter element is still wet
the filter will become obstructed and may be damaged
beyond repair.
 Dry the wet filter properly before use or replace it
with a dry one.
 Change the filter, if required, according to instruc-
tions under the section "Maintenance and Care".
Note: The dirt container needs to be emptied if it is full
until about 3 cm below the upper rim.
– Check the fill level of the dirt container at regular in-
tervals, as the appliance does not shut off automat-
ically during dry vacuuming.
Wet vacuum cleaning
CAUTION
Please observe the local provisions regarding the
wastewater treatment.
– Caution! If the appliance is used while the dirt
container is full, there is a chance that the shut-
off mechanism will respond late and the appli-
ance might become overfilled.
– If wet dirt is vacuumed with the crevice nozzle or if
high volumes of liquid are sucked up from a con-
tainer, it is recommended to deactivate the "Filter
Dedusting" function.
– If the maximum liquid level is reached the appli-
ance will turn off automatically.
– After the wet vacuuming: Clean the flat-fold filter.
Clean the thermal probe and the protective cover
with a moist cloth. Clean the container with a damp
rag and dry it.
Rotating knob
–
–
–
–
–
Turning on the Appliance
 Plug in the mains plug.
Indicator lamp "Ready for use" lights up.
 Switch on the appliance at the rotating knob.
Automatic filter cleaning
The appliance has an innovative dual filter cleaning sys-
tem that is particularly effective with fine dust. The flat
pleated filter is automatically cleaned every 7.5 seconds
through an air jet (pulsating sound).
Turn off the appliance
 Switch off the appliance at the rotating knob.
 Pull out the mains plug.
Indicator lamp "Ready for use" turns off.
Appliance ON
Filter dedusting OFF
Appliance OFF
Appliance ON
Filter dedusting ON
After each operation
Empty the container
 Lock parking brakes.
Illustration
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The container is un-
locked and lowered.
Illustration
 Pull the container out by the handle.
 Empty the container.
 Reinsert the container and lock it with the push handle.
WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the intermediate
ring or put them near the lifting mechanism
while locking. Lock the container by pressing
the sliding bow with both hands.
Cleaning the device
 Vacuum and wipe the appliance inside and outside
with a damp cloth.
Storing the Appliance
 Wrap the mains cord around the cable holder.
 Wind the suction hose around the sliding bow.
 Insert the floor nozzle and the suction pipe into their
respective holder.
 Place the appliance in a dry room and secure it
from unauthorized use.
CAUTION
Risk of injury and damage! Observe the weight of the
appliance when you transport it.
 Release the park brakes and push the appliance by
the push handle.
 Grab the appliance by the chassis, not by the slid-
ing bow to load it.
 When transporting in vehicles, secure the appli-
ance according to the guidelines from slipping and
tipping over.
CAUTION
Risk of injury and damage! Note the weight of the appli-
ance in case of storage.
This appliance must only be stored in interior rooms.
Care and maintenance
DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into place.
Clean the thermal probe
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The container is un-
locked and lowered.
 Pull the container out by the handle.
 Clean the thermal probe and the protective cover
with a moist cloth.
 Reinsert the container and lock it with the push handle.
– 2
EN
Transport
Storage
9