Bosch PLL 5 Manual Original página 21

OBJ_BUCH-311-008.book Page 21 Wednesday, April 27, 2016 9:57 AM
Aligning with the Laser Line
Horizontal Alignment (see figures C–D): Position the measuring tool
with the three supporting points 11 against the wall or with help of the
magnets 13, fasten it to the wall holder 1 or to another magnetic surface.
The aluminium supporting surface 7 of the measuring tool must face
downward. Align the measuring tool horizontally with help of the spirit
level 6. Picture frames or tiles, as an example, can be aligned alongside
the horizontal laser line.
Vertical Alignment (see figure D): Position the measuring tool with the
three supporting points 11 against the wall or with help of the magnets
13, fasten it to the wall holder 1 or to another magnetic surface. The exit
opening for the laser beam 8 must face upward. Align the measuring tool
vertically with help of the spirit level 5. Top and bottom cabinets, as an
example, can be aligned alongside the vertical laser line.
Alignment off of Reference Points (see figure E): Position the measur-
ing tool with the three supporting points 11 against the wall or with help
of the magnets 13, fasten it to the wall holder 1 or to another magnetic
surface. Turn the measuring tool to any angle in order to align the laser
beam to the reference points. In this manner, as an example, picture
frames can be hung parallel to a stairway or ceiling pitch.
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure F)
The measuring tool can be used as a contractors level for checking hori-
zontal or vertical lines, e.g., for the level set-up of a washer or a refrigera-
tor. Position the measuring tool with the aluminium supporting surface 7
facing against the surface to be checked. When positioning against hori-
zontal surfaces, the aluminium supporting surface 7 must face down-
ward. When positioning against vertical surfaces, the exit opening for the
laser beam 8 must face upward.
Working Advice
Mounting to a Wall
There are three methods for mounting the wall holder on various surfaces:
– Fastening with Pins (see figure G): With the pins 2 provided, the wall
holder can be fastened to drywall or wooden walls. Insert the pins
through the openings in the wall holder as shown in the figure.
– Fastening with a Screw: Place the wall holder 1 via the opening on the
back side onto a screw that projects lightly out of the wall.
Bosch Power Tools
English | 21
1 609 92A 2TP | (27.4.16)