Commissioning The Device; Automatic Switch-Off - ProMed HKP-1.6 XL Instrucciones De Empleo

COMMISSIONING THE DEVICE

Please check that the scope of delivery is complete before commissioning the device.
Ensure that the heating pad is not jammed.
Only use original parts!
Do not use the heating pad without the cover included in the scope of delivery!
Caution
Please ensure that the heating pad is attached loosely so that some air can circulate between
the heating pad and your skin.
Prevent heat accumulation at all costs.
WARNING – Risk of burning
• A prolonged use of the device at its highest settings can lead to burn injury
• To prevent burn injury to the skin, test the temperature of the device with the back of your hand before
using it (do not use the palm of your hand since it is less sensitive than other body parts).
• Do not put the heating pad directly onto your skin. Only use it on your clothing.
DE
Note:
A slight smell can develop when heating up the device for the first time. This is harmless. If applicable,
EN ensure that it is sufficiently ventilated.
1. Remove the protective film from the display of the control unit.
2. Check if both plugs (plug of the operating unit (J) and socket of the heating
pad (K)) are connected to each other. If this is not the case, connect these
FR
two correctly.
3. Insert the mains plug (A) into the socket. The On/Off LED (D) is illuminated
and "8" appears on the display (E); both expire after approx. 1 second.
IT
4. To switch on the heating pad, press the On/Off button (B); "1" will appear
in the display.
5. Press the temperature button (C) to set the desired temperature. You can set the desired temperature in
6 steps. Press the temperature button (C) again to increase the desired temperature. Once you have
ES
achieved the highest level "6", the settings start again at "1" by pressing it again.
Note:
NL
The heating pad needs approximately 15 minutes to reach the desired temperature.
Note:
RU The heating pad is equipped with a safety regulator, which regulates the heat and prevents the device
from getting too hot.
6. If you no longer wish to use the heating pad, press the On/Off button (B) to switch off the heating pad
and pull the mains plug out of the socket. Always pull at the plug, not the cable.
PL

Automatic switch-off

After 90 minutes, the heating pad switches off itself. The On/Off LED (D) is illuminated.
• Deactivate and activate the heating pad with the On/Off button (B).
SE
Note:
If you wish to use the heating pad for more than 90 minutes, wait 5 seconds after switching it off before
AR
restarting it again.