Descargar Imprimir esta página

Duronic MPS Manual De Instrucciones página 8

Ocultar thumbs Ver también para MPS:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
Tripod Mounted:
The brackets have holes to allow the screen to
be mounted on to tripods. In most cases, you will
need two tripod stands (one for each end of the
screen). Usually you will need two hooks and/or two
S-shaped hooks.
Please note: The only fixings included in the
box are raw plugs for brick walls. If you require
alternative fixings such as tripod stands, spacer
brackets or eyebolt screws you will need to buy
these separately.
Extending the Screen
Use the handle to slightly extend the screen out from the case, then continue
to extend until you reach the desired height. Gently tug the screen downwards
a little to automatically lock the screen into place.
Note: If the screen fails to lock in place, repeat the gentle tugging motion until
it is locked.
Retracting the Screen
To retract the screen back into the case, use the handle to pull the screen
down slightly and release the internal locking catch of the roller. The screen
will automatically roll back up into the case by itself. Do not let go of the screen
while it rolls back up, instead hold it and slowly guide it back into the case.
This will take care of the screen and prevent any damage occurring.
Cautions:
Make sure that the screen is extended from the casing gently.
Make sure that the screen is retracted back into the casing after each use.
Failure to do so may result in damage to the locking catch and can also
allow the screen to gather dust.
Operating Instructions
8

Publicidad

loading