Tripod Mounted:
The brackets have holes to allow the screen to
be mounted on to tripods. In most cases, you will
need two tripod stands (one for each end of the
screen). Usually you will need two hooks and/or two
S-shaped hooks.
Please note: The only fixings included in the
box are raw plugs for brick walls. If you require
alternative fixings such as tripod stands, spacer
brackets or eyebolt screws you will need to buy
these separately.
When first setting up the screen, check that you are happy with the position/
size of the black border and that the screen extends and retracts to the correct
positions. If it doesn't, this can be easily adjusted. Occasionally you may notice
that the screen does not extend to the correct length or completely retract.
This can easily be corrected and re-adjusted to rectify the problem.
'A' red/grey hex screw: controls the range of extension (how far the screen
goes down)
'B' white/yellow hex screw: controls the range of retraction (how much the
screen rolls up into the casing and at what angle it does so)
•
If there is a wide black border across the top of the screen and you
wish to decrease it, turn the "A" hex clockwise to narrow the width of
the black border.
•
If the black border across the top is too narrow or the screen hasn't
extended fully, turn the "A" hex anticlockwise.
•
If the screen extends wonky and needs straightening, adjust the "B"
hex to straighten the screen.
Setting up the Screen
Red Hex Screw - A
White Hex Screw - B
8
A
B