Power Saving Mode - Toshiba RAV-SM567CTP-E El Manual Del Propietario

◆ How to start swinging
1
Push , set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up / down wind
direction is automatically selected.
Display during swinging
Repeat
◆ How to stop swinging
1
Push at a desired position while the
louver is swinging.
When is pushed after that, wind direction
can be set again from the highest position.
* However, even if is pushed while the louver
is swinging, the louver position is displayed as
follows and highest position of the louver may not
be selected.
Display when swinging is stopped
Fan / Heat Cool / Dry
operation operation
In this case, push again two seconds later.
• In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
Display when stopping the swing
Fan / Heat Cool / Dry
operation operation
65-EN
◆ Unit select button
• When multiple indoor units are controlled with one
remote controller, wind direction can be set for each
indoor unit by selecting individually.
again.
• To set wind direction individually, push
button (left side of the button) to display an indoor
unit number in the control group. Then set the wind
direction of the displayed indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time button (left side of the button) is
pushed, the display changes as follows:
Unit No. Unit No. Unit No.
1-1 1-2
Not Unit No.
display 1-4
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
• When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
• When the horizontal louver is pointing horizontally in
HEAT mode, the air may not warm up the room
evenly.
– 33 –
7

Power saving mode

The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity
that the unit can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
• disappears.
 To configure the power saving mode settings
1-3
When RAV-SP***2AT / RAV-SM***3AT or older is used, the displayed setting changes, but the actual power level
is always "75 %".
1
Push button for at least four seconds when the air conditioner is not working.
• , symbol, and numbers flash.
2
Push (left side of the button) to select an indoor unit to be set.
• Each time you push the button, UNIT No. change as follows:
The fan of the selected unit runs.
button again.
2
4
5
UNIT No. UNIT No. UNIT No.
1-1 1-2 1-3
UNIT No.
1-4
1
3
66-EN