Parts Included: Refrigerator door handles (2), Refrigerator
drawer handle (1), Freezer drawer handle (1), ¹⁄₈" hex key, spare
setscrew(s)
Install Handles
Refrigerator Doors
NOTE: Handle mounting setscrews are preinstalled inside the
handle.
1. Remove the handles from the packaging inside the
refrigerator, and place them on a soft surface.
2. Open a refrigerator compartment door. On the closed door,
place a handle onto the shoulder screws so that the
setscrews are facing the adjacent door.
A
A. Shoulder screws
B. Setscrews inside the handle
3. Firmly push the handle toward the door until the handle
base is flush against the door.
4. While holding the handle, insert the short end of the hex key
into the upper hole and slightly rotate the hex key until it is
engaged in the setscrew.
5. Using a clockwise motion tighten the setscrew just until it
begins to contact the shoulder screw. Do not fully tighten.
6. Repeat steps 4 and 5 to fasten the lower setscrew.
7. Once both setscrews have been partially tightened as
instructed in the previous steps, fully tighten both setscrews.
14
Handle Installation and Removal
8. Repeat steps 2 through 7 to install the other handle onto the
Refrigerator and Freezer Drawers
1. With the drawer closed, place the handle onto the shoulder
B
2. Firmly push the handle toward the drawer until the handle
3. Insert the short end of the hex key into the left-hand hole
4. Using a left to right motion tighten the setscrew a quarter-
5. Repeat steps 11 and 12 to fasten the right-hand setscrew to
6. Once both setscrews have been partially tightened as
7. Save the hex key and all instructions.
IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.
adjacent refrigerator door.
screws so that the setscrews are facing down toward the
floor.
A. Shoulder screw
B. Setscrews inside the handle
base is flush against the drawer.
and slightly rotate the hex key until it is engaged in the
setscrew.
turn at a time just until it begins to contact the shoulder
screw. Do not fully tighten.
the shoulder screw.
instructed in the previous steps, fully tighten both setscrews.
IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.
A
B