Ecco ED3712 Instrucciones De Instalación Y Operación página 2

CONTENTS:
1 Light Head
1 Multi-Mount Base:
Includes-
2- M4x25 Sheet metal screws
2- Split washers
2- M3.5x10 screws
2- M3 washers
1 Adhesive Pad
1 Edge Mount Bracket:
Includes- 2- M3.5x10 screws
1 Surface Mount Bezel:
Includes- 2- 4x15 Sheet metal screws
1- EVA foam gasket
Mounting:
Surface Mount
FLASH GROUPING OR MODE----------------------GREEN
POSITIVE-----------------------WHITE
SYNCHRONIZATION--------------------YELLOW
PATTERN SWITCH-------------------------BLUE
POSITIVE--------------------------RED
NEGATIVE----------------------BLACK
Edge Mount
LIGHTHEAD BASE
ADHESIVE PAD
Color Switch:
Apply Green to Black wire:
MODE1 Color1
MODE2 Color2
MODE3 Color3
MODE4 Color 1&2
MODE5 Color 1&3
MODE6 Color 2&3
MODE7 Color 1&2&3
MOUNTING SURFACE
MOUNTING SCREWS
SPECIFICATIONS:
Input Voltage
Work Current
Important!
This unit is a safety device and it must be
connected to its own separate, fused power point to assure its
continued operation should any other electrical accessory fail.
Caution:
When drilling into any vehicle surface, make sure the
area is free from any electrical wires, fuel lines, vehicle upholstery,
etc. that could be damaged
Adhesive Mount
LIGHTHEAD BASE
Permanent Mount
MOUNTING
SCREWS
LIGHTHEAD BASE
Phase Operation:
Phase 1 (Ph1) flashes simultaneously with Ph1
Phase 2 (Ph2) flashes simultaneously with Ph2
Ph1 alternates with Ph2
(Up to 8 units can be synchronized)
Apply Blue to Black wire:
PUSH TIMES FUNCTION
0 ~ 1 sec. Next Pattern
1 ~ 3 sec. Previous Pattern
3 ~ 5 sec. Factory Default Pattern
5 ~ sec. Last Pattern
Operation Environment:
Ambient Temperature: -30ºC to 50ºC
10-30VDC
0.8A Max @ DC12V
ADHESIVE PAD
ADHESIVE PAD
Page 2 of 8