HACE MJS-501 Manual De Instrucciones página 4

Operating instructions
Before using the unit for the first time, keep the unit in room temperature for half an hour. Use
clear water no warmer than 40˚C. Check the water basin and make sure it is clear. Put the nozzle
into the socket on top of the water tank.
1. Put the machine on a flat surface.
2. Fill the water tank and tighten the tank cover.
3. Connect the water tank to the main body.
4. Check that the rated voltage meets the input voltage, and plug in the socket.
5. Switch on the machine. The light on the panel is activated and the machine begins to work.
6. Touch the symbol "MAX-MIN" to adjust the mist volume. On the remote control, just press the button
of "MIST VOLUME".
7. Touch the symbol with the trees to activate the air freshener. The ionization is activated and the
shape of trees is shown in the display. Touch again to stop the function.
8. Touch the symbol "HEATING" to activate the warm mist that will come out after 10 minutes. On the
LED display, the shape of fire is shown. Touch again to stop the function.
9. Constant humidity: Before you touch the symbol "HUMIDITY", the LED display shows the current
humidity. You may set the humidity from 45%RH to 90%RH. Press once to increase by 5%RH. When
it reaches 90%RH, press again to go back to 45%RH. After you set the desired humidity, the machine
will show the value for 5 seconds. After 5 seconds, the LED display shows the current humidity. The
machine will work when desired humidity is lower than current humidity.
10. Timer setting: There are 12 timer settings: 1,2,3,4,5,6,7,8,9,10,11,12 hours. Touch the symbol "TI-
MER" and the LED display will show the timer. Once you have set the timer, the value of time remaining
in timer and the room temperature will display 30 seconds alternating in the middle of LED display.
11. Once there is too little water in the basin to keep the machine working, the machine will automati-
cally stop working. LED shows the shape of lack of water. Refill the water, and the machine will restart.
Maintenance
If you live in an area with hard water, which means that the water contains too much calcium
and magnesium, it can cause "white powder" and scales on the water basin, transducer and
inner surfaces of the water tank. Scales on the surface of transducer will unable the unit work to
properly.
We recommend:
1. Use cold boiled water or distilled water.
2. Clean the transducer, water tank and basin unit every week.
3. Change the water in water tank more often to keep it fresh.
4. Change the water in regularly and clean and dry the water tank before storing the machine.
5. If you plan not to use the unit for a longer period of time, clean the whole unit and make sure
that all parts of the unit are dried completely before storing.
4