Startup And Operation Of The Twistorr 305 Fs - Agilent Technologies TwisTorr 305 FS Manual De Instrucciones

Startup and Operation of the TwisTorr 305 FS

To turn on the TwisTorr 305 FS via the on board controllers or the remote
controllers, connect the pump to the controller, supply the controller with
the proper supply voltage and then act on the "START" and "INTERLOCK"
signals (which are located on the controller's interface).
Once these signals are recognized the controller will start the pump.
Please refer to the controller's relevant instruction manuals in order to:
NOTES
(1) Find the location of the power supply inlet as well as the mains input voltage
admitted values (Remote: Chapter Technical Information; On Board: Chapter
Technical Information).
(2) Find the location of the START/STOP and INTERLOCK input pins as well as
the related electrical ratings (Remote: Chapter Technical Information; On
Board: Chapter Technical Information)
(3) Find details about how to connect the START/STOP and the INTERLOCK
signals (Remote: Chapter Technical Information; On Board: Chapter Technical
Information).
Controller MPNs
X3507-64130
X3507-64131
X3506-64130
X3506-64131
WARNING! The initial startup of the pump will be in "SOFT START" mode; for detailed
information on this mode refer to the dedicated section on page 208.
TwisTorr 305 FS User Manual / 87-901-057-01 (A.00)

Startup and Operation of the TwisTorr 305 FS

Controller Descritpion
Twistorr 305 FS onboard 24V
Twistorr 305 FS onboard 110/230V
Twistorr 305 FS AG Remote RS232/485
Twistorr 305 FS AG Remote Profibus
Instructions for Use
Ref.Instruction
Manual
87-901-060-01
87-901-060-01
87-901-059-01
87-901-059-01
205/258
7