Hach TL2310 Manual Básico Del Usuario página 4

Specification
Response time
Stabilization time
Reading modes
Communication
Interface
Datalog
Air purge
Sample cells
Sample requirements
Certification
Warranty
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Additional information
Additional information is available on the manufacturer's website.
2.2 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
2.2.1 Use of hazard information
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or
serious injury.
4 English
Details
Signal averaging off: 6.8 seconds
Signal averaging on: 14 seconds (when 10 measurements are used to
calculate the average)
Immediately
Single, continuous, Rapidly Settling Turbidity
USB
2 USB-A ports for USB flash drive, Seiko DPU-S445 printer, keyboard
and barcode scanner
Maximum 2000 total logs, includes reading log, verification log and
calibration log
Dry nitrogen or instrument grade air (ANSI MC 11.1, 1975)
0.1 scfm at 69 kPa (10 psig); 138 kPa (20 psig) maximum
Hose barb connection for
Round cells 95 x 25 mm (3.74 x 1 in.) borosilicate glass with rubber-lined
screw caps
25 mm sample cell: 20 mL minimum
0 to 70 °C (32 to 158 °F)
CE, KC, RCM
1 year (EU: 2 years)
D A N G E R
™
, signal averaging on or off
1
/ -inch tubing
8