Generac 1908-0 Manual Del Propietário página 6

Generac Portable P roducts 1900 PSI P ressureWasher
ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
Remove Pressure Washer From
Carton
I. Remove the parts bag,accessories,and inserts included
with pressure washer.
2. Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat.
3. Remove pressure washer from carton.
Carton Contents
Items in the carton include:
Main Unit
Handle
High Pressure Hose
SprayGun
Nozzle Extension
Safety Goggles
Oil Bottle
Parts Bag(which includesthe following):
Owner's Manual
Engine Manual
Owner's Registration Card
Handle Attachment Hardware
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,call the
pressure washer helpline at 1-800-270-1408. If calling for
assistance,pleasehave the model, revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handleto main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
Attach Handle
]. Placehandleassembly onto handlesupportsconnected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure I).
Alig
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from insideof unit
(Figure 2).Tighten by hand.
.
Insert one "L" hooksthrough hole just under billboard
on left side of handle (viewing from rear of unit). Hold
hook in place with pliers and attach locknut with
7/16" wrench (Figure 3).
;pray Gun
Hook
4.
Insert other"L" hook through hole just above
billboard on right side of handle (viewing from rear of
unit). Hold hook in place with pliers and attach locknut
with 7/16" wrench (Figure 3).
/
6