Livestrong LS10.0T Manual Del Propietário página 6

ASSEMBLY STEP 1
HARDWARE BAG 1 CONTENTS :
BOLT (A)
20 mm
Qty: 6
CONSOLE MAST
MAIN
FRAME
BOOT
BOLTS (A)
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
6
SPRING WASHER (B) ARC WASHER (C)
8.2 mm 8.2 mm
Qty: 6 Qty: 6
LEAD WIRE
CONSOLE CABLE
Cut the yellow banding straps and lift the
A
running deck upward to remove all contents
from underneath the running deck.
Open hardware bag 1.
B
Slide main frame boot up console
C
mast. Place right console mast over
main frame bracket.
Pull lead wire through right console
D
mast. After pulling the lead wire through
the mast, the top of the console cable
should be located at the top of the mast. Detach
and discard lead wire.
NOTE: Do not pinch console cable when
placing the mast onto the main frame
bracket.
Attach console mast to main frame
E
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
Slide main frame boot down over main
F
frame bracket.
Repeat steps D–F on other side.
g