want to use the Volume keys of the Amplifier for
the DVD.
To change the volume keys:
1 .
Select the option Copy volume in the Set-
up menu by using the cursor Keys. Press
.
OK
2.
Select the device you want to copy the
Volume keys from (e.g. TV or AMP or
RECEIVER). Press
3.
Select the device you want to copy the
Volume keys to (e.g. DVD or SAT).
Press
.
OK
4.
Confirm you want to copy the Volume
keys from one device to the other by
selecting "Yes". Press
and Mute key are copied.
5.
To return to the Set-up menu, select "Exit".
Press
.
OK
5.10 Changing display time out
To save power, your universal remote for iPod™
will switch off when it is not used for a while.
This is the display time out. You can change this
time out to one of the following:
• Short
• Medium (default)
• Long
To change the display time out:
1.
Select the option "Display Time Out" in
the Set-up menu by using the cursor keys.
Press
.
OK
2.
Select your preferred display time out
Press
. The time out is changed for
OK
your universal remote for iPod™.
The Set-up menu appears on the screen.
D
Note
The display time out has an impact on the life of
the batteries. The longer the backlight stays on,
the faster the batteries will be drained.
Warrantee & Serivice
SJM315Final.indb 21
.
OK
. The Volume keys
OK
5.11 Performing a full reset
You can reset your universal remote for iPod™
completely, deleting all programmed devices,
activities, learned keys and other settings. After
the reset, you will have to configure your remote
again.
To perform a full reset:
1.
Select the option "Full Reset" in the Set-up
menu by using the cursor Keys. Press
2.
Confirm you want to perform a full reset
by selecting "Yes". Press
3.
Press
to reconfirm. The remote control
OK
deletes all settings. When the full reset
is ended, the remote automatically re-
initializes. You now have to configure your
remote again. See section 3.3, Install, and
follow the directions for pairing the dock
with the remote to repeat this procedure.
.
OK
.
OK
21
8/14/07 4:10:32 PM