Publicidad
Idiomas disponibles
Idiomas disponibles
My remote control does not work.
What should I do?
iHow
Comethe Initial SetuP appears every
time Iturn on this unit?
Why I cannot watch some of TV programs?
HoW come there is no imag
connected
external
devices?
Whenever
I entered channel
number,
it changes automatically.
Why are captions
not displayed
entirely ?
Or, captions
are delayed
behind the
dialogue.
. Check the antenna
or cable connection
to the main unit.
, Check the batteries of the remote control.
, Check if there is an obstacle between
the infrared sensor window
and the
remote control.
, Test the signal output.
If OK, then possible infrared
sensor trouble.
(Refer to"lR Signal Check" on page 36.)
, Aim the remote control
directly at the infrared
sensor window
on the
front of the unit.
, Reduce the distance
to the unit.
, Re-insert the batteries
with their polarities
(+/- signs) as indicated.
, When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control
signal of this unit.
, Move the infrared-equipped
device away from this unit, change the angle
of the infrared
sensor or turn off the infrared communication
function.
, Connect
theRF coaxial cable to the Unit directly
and run the initial setup:
Make sure to complete
the channel
scan before turning
offthe
unit.
, Make sure autoscan
has been completed.
(Refer to"Autoscan"
on page 18.)
, Autoscan
must be completed
when you set up the unit for the first
time or move it to a location
where previously
unavailable
channels are
broadcast.
, The selected
channel
may not be broadcasting.
, When autoscan
is interrupted
and not completed,
some channels will not be received. Make sure to complete.
(Refer to "Autoscan"
on page 18.)
, The selected
channel cannot
be viewed by the"Child
Lock"setting.
(Refer to "Child Lock" on page 26.)
, The unit requires some kind of antenna
input. An indoor
antenna
(rabbit
ears), an external
antenna,
or an RF coaxial cable from your wall or cable
receiver / satellite box needs to be plugged
into the unit.
.Check
if the right input mode is selected
by pressing
using [CH A/T1.
(Refer to"Switching
Each Input
Mode"on
page1S,)
o Check the antenna
or cable connection
tothe
unit.
. Many digital
channels have alternate
channel
numbers. The unit changes
the numbers
automatically
to the ones signifying
the broadcasting
stations. These are the numbers
used for analog
broadcasts.
_ Cap!ons
that are delayed
a few seconds behind the actual dialogue
are:
common
for live broadcasts,
Most captioning
p[oduction
companies
can
display a dialogue
to maximum
Of 220 Words laer minute.
If a dialogue
exceeds that rate, selective editing
is used to insure that the Captions
remain
up:to date with the current TV screen dialogue.
How can I set the clock?
, There is no clock function
on this unit.
EN
Publicidad
