Axxess GMOS-13 Instrucciones De Instalación
Ocultar thumbs Ver también para GMOS-13:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation instructions for part GMOS-13
GM Data Interface
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake,
reverse, speed sense)
• Retains chimes
• Pre-wired ASWC-1 harness
(ASWC-1 sold separately)
• GMOS-13 interface • GMOS-13 harness
• 16-pin harness with stripped leads
CADILLAC
STS
®
Axxess Integrate
®
GMOS-13
2005-2011
INTERFACE FEATURES
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
• Designed for amplified models
• Retains balance and fade
• USB-CAB (sold separately) updatable
INTERFACE COMPONENTS
APPLICATIONS
2005-2011
axxessinterfaces.com
Connections to be made .........................................2
Installing the GMOS-13 ..........................................3
Initializing the GMOS-13.........................................3
Adjusting the GMOS-13 ..........................................3
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
CAUTION!
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
metraonline.com
Table of Contents
All accessories, switches, climate controls panels, and
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION

Publicidad

Capítulos

Tabla de contenido
loading

Resumen de contenidos para Axxess GMOS-13

  • Página 1 • USB-CAB (sold separately) updatable • Small flat-blade screwdriver • Pre-wired ASWC-1 harness (ASWC-1 sold separately) INTERFACE COMPONENTS • GMOS-13 interface • GMOS-13 harness • 16-pin harness with stripped leads CAUTION! APPLICATIONS All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling CADILLAC the ignition.
  • Página 2: Connections To Be Made

    Note: If installing an ASWC-1 (sold separately), there will be an accessory wire there to connect as well. From the GMOS-13 harness to the aftermarket radio: • Connect the Blue/White wire to the amp turn on wire. This wire must be •...
  • Página 3: Installing The Gmos-13

    • Connect the GMOS-13 harness to the wiring harness in the vehicle. raise the audio level; counterclockwise to lower the audio level. Note: If using the ASWC-1, connect it after you initialize and test the GMOS-13, • Once at a desired level, audio level adjustment is complete.
  • Página 4 ® Installation instructions for part GMOS-13 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
  • Página 5 ® Instrucciones de instalación para la pieza GMOS-13 Indice GMOS-13 Interfase de Datos GM Conexiones que se deben hacer ......2 Instalación del GMOS-13 ........3 2005-2011 Inicialización del GMOS-13 ........3 Ajuste del GMOS-13 ..........3 CARACTERÍSTICAS DE LA INTERFASE • Provee corriente de accesorios (12 voltios •...
  • Página 6: Conexiones Que Se Deben Hacer

    • Conecte el cable azul/blanco con el cable de encendido del amplificador. Este Del arnés GMOS-13 al radio de mercado secundario: cable debe estar conectado para escuchar sonido del amplificador de fábrica. • Conecte el cable negro al cable de tierra.
  • Página 7: Instalación Del Gmos-13

    Con la llave en la posición de apagado: Ajuste del nivel de audio: • Conecte el arnés de 16 pins con conectores pelados, y el arnés GMOS-13, a la • Con el vehículo y el radio encendidos, aumente el volumen hasta 3/4 de su totalidad .
  • Página 8 ® Instrucciones de instalación para la pieza GMOS-13 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...

Tabla de contenido