Technical Parameters - Flo 79880 Manual De Instrucciones

PROPERTIES OF THE DEVICE
Submersible pumps are designed to pump clean and slightly contaminated water from reservoirs (e.g. swimming pools, garden
ponds) in an intermittent working cycle. The product is not intended for commercial use. By no means is it permitted to pump other
liquids than water, such as oils, gasoline, solvents, acids, bases, fats or water contaminated with other substances. The pumped
water should not contain mechanical contaminants or other abrasive particles. Pumping contaminated water is acceptable solely
when special precautions have been taken and if the pumping process is being continuously controlled.
Attention! Any interruptions of the fl ow of water through the pump may lead to its irreversible damage!
A correct, reliable and safe functioning of the appliance depends on its correct operation, so:
Before you proceed to work with the device, read thoroughly the operating manual and keep it for further reference.
The supplier will not be held responsible for any damage caused by failure to observe safety regulations and the recommendations
included in this manual.
EQUIPMENT
The original factory box contains a pump with a socket ferrule to connect a hose. The pump is not supplied with a pumping conduit
(hose).

TECHNICAL PARAMETERS

Pump type
Parameter
Power supply voltage
Power supply frequency
Nominal power
Insulation class
Protection grade (IP)
Maximum capacity
Minimum - Maximum head
Maximum immerse depth
Maximum water temperature
Water outlet diameter
Maximum diameter of foreign matter
Dimensions (diameter x height)
Net weight
Power on level
Power off level
Minimum dimensions of the shaft
Attention! In order to ensure the maximum effi ciency of the appliance, connect to the pump a hose whose diameter corresponds
to the maximum diameter of the water connection.
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The notion of
electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and wireless ones.
O P
8
Head high [m]
3
4
5
6
7
8
9
E R A T I
GB
Measure unit
[V]
[Hz]
[W]
[dm /h]
3
[m]
[m]
[ C]
o
['']
[mm]
[mm]
[kg]
[m]
[m]
[cm.]
N G M A
79880
Value
~230
50
450
I
IPX8
16 000
3 - 9
5
35
40
25
230 x 440
14,4
ok. -0,5
ok. -0,07
40 x 40 x 50
Pump type
79880
Capacity [dm /h]
3
16 000
12 000
9 000
6 500
4 000
2 000
500
N U A L