AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 10°C and 32°C. If
these temperatures are exceeded, i.e. colder or warmer, the appliance will not operate cor-
rectly.
MOVING YOUR APPLIANCE
•
Make sure that the appliance is unplugged from the mains socket. Remove all bottles and
shelves to avoid any shock.
•
Always move the appliance vertically.
•
After moving, wait for 30 minutes before plugging in the appliance.
Your appliance uses isobutane (R600a) as a refrigerant Although R600a is an environmen-
tally friendly and natural gas, it is explosive. Therefore you should be careful during shipment
and installation to prevent your appliance's cooler elements from being damaged. In the
event of a leak caused by damage to the cooler elements, move your appliance from open
flame or heat sources and ventilate the room where the appliance is located for a few min-
utes.
BEFORE FIRST USE
Remove all packaging.
Clean the interior surface with lukewarm water using a soft cloth. Dry thoroughly.
OPERATION
Ensure that the appliance is placed on a flat and stable surface.
Plug the appliance into the mains socket The display will show the current actual tempera-
ture of the internal cabinet
Allow the appliance to cool down for 2-3 hours before placing wine bottles in the appliance.
SELECTING THE TEMPERATURE
The temperature can be set from 4°C to 18°C. The default factory temperature is set at 12°C.
1. Repeatedly press to select the required temperature.
• Each time you press
, the temperature will be increased or decreased by 1°C.
2. The temperature selected will flash on the display for approximately 3 seconds, then the
display will return to the current actual temperature of the internal cabinet.
• The current actual temperature will vary depending on the quantity of bottles stored and
how often the door is opened.
• To view the set temperature, press
for approximately 3 seconds and then return to the current actual temperature of internal
cabinet.
• The temperature display can be switched between Celsius (°C) and Fahrenheit (°F) by
pressing and holding
. The corresponding indicator light °C or °F will illuminate.
INTERIOR LIGHTS
Press
to turn the interior lights on or off.
30
,the set temperature will flash on the display
The Wine Cooler is recommended to be designed at 12°C.
The shelves are placed in factory mode that results in the most efficient use of energy for
the refrigerating appliances.
NOTE: Setting the temperature too high can cause the wine to spoil, and setting the tem-
perature too low can waste electricity.
TIPS FOR STORING WINE
Store wine in sealed bottles.
Do not overload the appliance. The maximum number of bottles that can be stored is 46,
depending on the size of bottles.
To achieve the maximum capacity of the appliance, the bottles should be laid out as shown.
Here's the standard 750ml Bordeaux shape and size in mm
AUTOMANTIC DEFROSTING
Ice build-up on the inner backwall during compressor operation will defrost automatically
when the compressor has cycled off.
Defrost water will drain out through the drain outlet into a drain pan from where it will evap-
orate.
OPERATING NOISES
Normal noises
•
Motors are running.
•
Refrigerant is flowing through the tubing.
TIPS FOR SAVING ENERGY
For the most energy efficient use of your appliance :
•
Ensure your appliance has adequate ventilation as recommended in the installation in-
GB
31