Marina Splash Manual De Instrucciones página 5

2 - INTRODUCING FISH
ADD A HEATER
filter cartridges (ill. C)
DO NOT ADD FISH IMMEDIATELY.
into your aquarium.
ATTENTION: Do not move the Marina Splash once it is full of water.
FEEDING YOUR FISH
DO NOT OVERFEED YOUR FISH
consume in two minutes. once a day.
3 - AQUARIUM CARE AND MAINTENANCE
WARNING: ALWAYS DISCONNECT APPLIANCES IN THE AQUARIUM FROM THE ELECTRICAL SUPPLY BEFORE PLACING HANDS IN THE WATER, BEFORE PUTTING ON OR TAKING OFF
PARTS, AND WHENEVER THE FILTER EQUIPMENT IS BEING INSTALLED, MAINTAINED OR HANDLED.
DO NOT
water, and may cause damage to the unit or the support surface.
DO NOT USE OR PLACE ANYTHING THAT HAS COME IN CONTACT WITH SOAP IN THE AQUARIUM
REGULAR MAINTENANCE
gravel cleaner to ensure cleanliness and to reduce build up of unwanted nitrate and waste. Replace with tap water of similar temperature, and add the correct doses of water
conditioner and biological aquarium supplement. NOTE:
REPLACING FILTER CARTRIDGES
MOTOR CLEANING
of the motor.
1.
2. Remove the inlet cover and then the impeller cover. Pull the impeller from the impeller well (ill. F).
3. Rinse impeller under water and wash off any slimy build-up that has accumulated
on the impeller and in the impeller well, and reassemble.
Important: DO NOT use chemical cleaners.
4.
CLEANING THE FILTER/LED UNIT
1.
2. Rinse filter tube or clean with a cleaning brush.
(ill. D).
NOTE:
(ill. E).
E
C
D
F