Slime 40067 Manual Del Usuario página 4

TROUBLESHOOTING
Inflator does not turn ON:
1. Check the power plug and push it firmly into the receptacle, twist back and forth.
2. Check receptacle and plug terminals for dirt, or debris. (Use a non-conductive
probe, not fingers or metal).
3. Check vehicle power outlet fuse. It should be 15 amps minimum.
4. Check the fuse. It may have blown: 12V fuse is located
in the plug adaptor: unscrew the tip, remove fuse, and
inspect. If necessary, replace fuse with 15A 250V 5mm
x 20mm.
5. Check to see if the pre-programmed INFLATE RIGHT
digital gauge is set to a lower PSI than your tire currently
is reading (i.e., the digital gauge is set to 15psi but your tire is at 20psi; in this
scenario, the inflator will not turn on) and set the PSI to the correct tire pressure.
Refer to Inflate Right™ Technology operating instructions.
Inflator runs but does not inflate:
1. Be sure the air hose valve connector is fully secured on the tire valve.
2. Check tire for leaks, and check hose for breaks and leaks at fittings and check valve
core for damage.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool
for 25 minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.
NOTE:
If tire is totally deflated, it is possible that the tire could separate from the
rim allowing air to leak out when trying to inflate. In the event this occurs, it may be
necessary to jack up the tire prior to inflation.
Dispose of this product at an e-waste recycling collection point or facility.
Do not place in the trash or standard recycling receptacle.
FOR WARRANTY INFORMATION GO TO: WWW.SLIME.COM / WARRANTY
QUESTIONS OR COMMENTS: Call (888)457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.
12V fuse