Getting Started; Operation - THERMOBILE ITA ROBUST Serie Manual Del Usuario

3

GETTING STARTED

3.1 Remove packaging
1. Remove the packaging from the heater.
3.2 Installation
1. Make sure that the heater is placed
horizontally.
2. Fill the tank with fuel.
Caution
Use only diesel oil or paraffin.
Caution
• Be careful when you fill the tank.
Remove any spilled oil from the
heater and the ground.
• Gas oil tends to thicken at low
temperatures. This can block the
filters. Add a maximum of 15%
paraffin to the fuel at
temperatures below -5 °C, or
keep the fuel frost-proof, or use
tank heating (optional).
3. Make sure there is sufficient distance
between the wall and the air inlet.
Minimum distance is 1 m.
4. Make sure that the heated air can flow
without obstruction. Minimum distance
from outlet to an obstacle is 2 m.
5. Check the ventilation surface area: for
each kW a surface of 25 cm
6. Check the connection of the room
thermostat.
Do not remove the cap when you do not
use a room thermostat.
Remove the cap to connect a room
thermostat.
7. Install the flue (1 m and a raincover).
8. Make sure the On/Off switch is in the
0 position.
9. Check the supply voltage: see the
identification plate.
10. Put the plug in the socket.
11. Press the reset switch.
T I / A T I A S
ITA 45/75 ROBUST
3.3
1. Press the On/Off switch to switch on the
2. Set the room thermostat.
4
4.1
4.2
1. Switch off the heater.
2 is needed.
2. Disconnect the electric power.
4 0 0 . 2 0 0 . 0 5 - e r . v 0
40.019.005 rev 00 - 2013
Power up
heater.
Caution
Do not switch on the heater when the
tank is empty!
The heater supplies warm air after
approximately 10 seconds.
Caution
The fuel system de-aerates through
the nozzle. Close down may occur
several times when starting with an
empty filter. To rectify: press the reset
switch.

OPERATION

During operation
Hot
Do not touch the flue with rain cover,
nor the air outlet! The flue with rain
cover and the air outlet become hot
during operation!
Power down
The magnet valve closes and stops the
fuel supply.
Caution
After you switch off the heater, the
fan still rotates. The fan cools the
heater to avoid damage caused by
overheating. The fan stops
automatically.
Do not remove the plug from the
socket until the heater fully stops!
Caution
Do not disconnect the electric power
when using the tank heating.
7 - 2 0 1 1
English
1 7
17